Troubleshooting Informatica Error Messages and Resolution – Part 71

CFG_10081Object at full path <full path of object> cannot be found in the domain.
Cause:A request was received for an object that cannot be found.
Action:Verify that the object path and the object name are correct.

CFG_10082The value <option value> for option <option name> of service <service name> is not valid.
Cause:The option value specified for the service is not valid.
Action:Check to make sure option specified is valid.
CFG_10083The operating mode of service <service name> cannot be changed to safe mode while the service is enabled.
Cause:The operating mode cannot be changed to safe while the service is enabled.
Action:Disable the service first.
CFG_10084Cannot move the root folder.
Cause:A request was received to move the root folder.
Action:None. You cannot perform this protected operation.

CFG_10085Cannot move a folder to one of its subfolders.
Cause:A request was received to move folder to one of its subfolders.
Action:Select a different target location.
CFG_10086Cannot perform operation on an unassociated node <node name>.
Cause:An attempt was made to perform an operation on an unassociated node.
Action:Associate the node first.
CFG_10087Service <service name> contains references to linked domains <list of linked domains> not defined in the domain.
Cause:A request was received to add a service referencing undefined linked domains.
Action:Link the domains.
CFG_10088Node <node name> was modified to be a gateway node in the domain but failed to update node metadata file.
Cause:A problem was encountered communicating with the node that did not update its metadata file.
Action:Go to the node and run infacmd defineGatewayNode to match domain definition.
CFG_10089Node was modified to be a worker node in the domain but failed to update node metadata file.
Cause:A problem was encountered communicating with the node that did not update its metadata file.
Action:Go to the node and run infacmd defineWorkerNode to match the domain definition.
CFG_10091The full path was not specified for object .
Cause:A request was received for an object requiring the full path.
Action:Provide the object full path.

Above are list of Informatica Error Messages or Warnings received while performing certain operation against Informatica related products.

 

What are Informatica Error Messages?

Informatica error codes are a set of error codes for use by all Informatica products. Every Informatica error message returned by Informatica, is self explanatory and contains the object name in cases where required.

Hope this was helpful.

Thanks,
SQLServerF1 Team
Information about Informatica Error Code Messages or Warning Messages on Windows and Linux Operating Systems.

 

Leave a Reply

Your email address will not be published. Required fields are marked *