Troubleshooting Informatica Error Messages and Resolution – Part 5

SQLServerF1

Port cannot be used in a Join Complexity Evaluation function, because it is of the datatype ‘binary’.
Cause:A port with a Binary datatype was specified while adding or editing a Join Complexity Evaluation function.
Action:Specify a port with a datatype other than Binary.
Profile information does not exist in the target warehouse.
Cause:The profile session did not run against the Data Profiling warehouse for which you are trying to view reports.
or
Cause:The profile was modified, and no profile session ran after the profile was modified.
Action:Run a profile session against the Data Profiling warehouse for which you are trying to view reports.

Profile was created successfully but mapping representing this profile is not valid. This profile cannot be run in interactive mode.
Cause:Internal error.
Action:Contact Informatica Technical Support.
Profile was successfully created but no Integration Service is registered to run the profile.
Cause:Data Profiling successfully created the profile but could not run the session because an Integration Service is not registered for the data profiling repository.
Action:Register an Integration Service for the data profiling repository.

Profile was updated successfully but mapping representing this profile is not valid. This profile cannot be run in interactive mode.
Cause:Internal error.
Action:Contact Informatica Technical Support.
Profiling for this source is not supported.
Cause:Internal error.
Action:Contact Informatica Technical Support.
Regular expression is invalid.
Cause:An invalid regular expression was specified.
Action:Make sure that the regular expression contains valid characters.

Above are list of Informatica Error Messages or Warnings received while performing certain operation against Informatica related products.

What are Informatica Error Messages?

Informatica error codes are a set of error codes for use by all Informatica products. Every Informatica error message returned by Informatica, is self explanatory and contains the object name in cases where required.

Hope this was helpful.

Thanks,
SQLServerF1 Team
Information about Informatica Error Code Messages or Warning Messages on Windows and Linux Operating Systems.

 

Leave a Reply

Your email address will not be published. Required fields are marked *