Troubleshooting Informatica Error Messages and Resolution – Part 420

SQLServerF1_Header_Small

WRT_8157Field of the output file is not wide enough to fit at least one specified NULL character.
Cause:You specified a multibyte null character and the target field does not contain enough remaining bytes for one null character.
Action:Specify a single byte null character.
or
Action:Increase the target column size in the Designer.

WRT_8171Cannot locate CreateWrtTargetInstance function in the shared library.
Cause:The DLL loaded for the specified target does not contain a function called CreateWrtTargetInstance.
Action:Make sure this is the correct DLL.
WRT_8172Cannot create ASCII locale.
Cause:Third party library error.
Action:Make sure the paths to libraries and environments are set properly.
WRT_8173Conversion from UNICODE failed – not all the characters were converted.
Cause:The number of characters converted from Unicode does not match the number of characters in the buffer. The number is less than the expected number.
Action:Contact Informatica Technical Support.

WRT_8174Error while flushing the buffer to output file . Error message is , data buffer .
Cause:There was an operating system input/output error trying to output into target file.
Action:Check that the output file is not locked and has the correct user permissions. Make sure the system has enough disk space.
WRT_8175Field separator string for file contains non-ASCII characters .
Cause:At initialization time, the Integration Service is in ASCII data movement mode, but the field separator string specified in the session for that target file contains some non-ASCII symbols.
Action:Change the Integration Service to UNICODE data movement mode or change the field separator string to be ASCII-only.

Above are list of Informatica Error Messages or Warnings received while performing certain operation against Informatica related products.

What are Informatica Error Messages?

Informatica error codes are a set of error codes for use by all Informatica products. Every Informatica error message returned by Informatica, is self explanatory and contains the object name in cases where required.

Hope this was helpful.

Thanks,
SQLServerF1 Team
Information about Informatica Error Code Messages or Warning Messages on Windows and Linux Operating Systems.

 

Leave a Reply

Your email address will not be published. Required fields are marked *