Troubleshooting Informatica Error Messages and Resolution – Part 389

SQLServerF1

TM_6332Error deleting recovery information for target <target>.
Cause:The Integration Service could not remove recovery information for the specified target from the recovery tables.
Action:Verify that the recovery tables exist on the target database. Check previous error messages for possible causes of the error. Verify that the database user name specified in the target database connection has permission to create, access, and update the recovery tables.

TM_6335Error: Connection object failed to initialize while establishing DB Connection.
Cause:Internal error.
Action:Contact Informatica Technical Support.
TM_6336Error: No recovery information found for the target <target>. Recovery run failed to initialize.
Cause:The Integration Service could not start the recovery session because it could not locate the recovery table or information in the recovery table.
Action:Verify that the recovery tables exist on the target database. If the tables do not exist, you must run the session again normally with recovery enabled to create the tables and insert recovery information into them. You can also manually create the recovery tables and then run the session normally to create recovery information.
or
Action:If the recovery tables exist, run the session normally to create recovery information. Do not drop the recovery tables while the session is enabled for recovery.

TM_6340Error: no recovery info found in the target RDBMS for target <target> partition <partition number> in this session. Recovery is not possible.
Cause:The recovery session because the Integration Service could not locate recovery information in the recovery tables for the specified session and partition.
Action:To insert recovery information in the recovery tables, run the session again normally. If the session fails, you can recover it. Do not delete information from the recovery tables before performing recovery.
TM_6341Error: <number of records> recovery records were updated in the recovery table. Expected exactly one row to be updated.
Cause:The Integration Service could not update the recovery tables due to a database error.
Action:Check the database error message log for possible causes of the error, and contact the database administrator.
Action:To ensure consecutive execution of target load order groups, set the target load order from the Mappings tab in the Designer.

Above are list of Informatica Error Messages or Warnings received while performing certain operation against Informatica related products.

What are Informatica Error Messages?

Informatica error codes are a set of error codes for use by all Informatica products. Every Informatica error message returned by Informatica, is self explanatory and contains the object name in cases where required.

Hope this was helpful.

Thanks,
SQLServerF1 Team
Information about Informatica Error Code Messages or Warning Messages on Windows and Linux Operating Systems.

 

Leave a Reply

Your email address will not be published. Required fields are marked *