Troubleshooting Informatica Error Messages and Resolution – Part 382


TM_6264Connection is not set in the Workflow Manager for the MQ Source Qualifier transformation <MQ Source Qualifier name> partition <partition name>. The session failed.
Cause:The Integration Service cannot find the queue connection you specified. As a result, the session failed.
Action:Assign a valid queue connection to the session. Then, validate the session.
TM_6279 Session instance <session instance name> runtime validation error: <error message>.
Cause:The Integration Service could not run the session because it is invalid.
Action:Review the runtime error message.
Cause:PowerCenter requires that the buffer size is ten times larger than the buffer block size. The session might be invalid if you upgraded a session from version 6.0 that did not meet these requirements.
Action:Edit the session properties so that the buffer size is at least 10 times greater than the buffer block size.

TM_6294ERROR: Target Load Order has been changed. Mapping <mapping name> needs to be revalidated.
Cause:If you modify a mapplet associated with a mapping in such a way that the target load order for the mapplet changes after you saved the mapping, the Integration Service cannot run a session using the mapping.
Action:Open the mapping and save it. Run the session again.

TM_6316Error: <database error message> in setting up PM_TGT_RUN_ID table.
Cause:The user name specified in the target database connection does not have table creation privileges on the target database. As a result, the Integration Service could not create the PM_TGT_RUN_ID recovery table.
Action:Grant table creation privileges to the database user name specified in the target database connection.
Cause:The Integration Service could not create the PM_TGT_RUN_ID recovery table due to a database error.
Action:Check the database error message to determine the cause of the error, and contact the database administrator.

Above are list of Informatica Error Messages or Warnings received while performing certain operation against Informatica related products.

What are Informatica Error Messages?

Informatica error codes are a set of error codes for use by all Informatica products. Every Informatica error message returned by Informatica, is self explanatory and contains the object name in cases where required.

Hope this was helpful.

SQLServerF1 Team
Information about Informatica Error Code Messages or Warning Messages on Windows and Linux Operating Systems.


Leave a Reply

Your email address will not be published. Required fields are marked *