Troubleshooting Informatica Error Messages and Resolution – Part 378


TM_6091ERROR: reader wait thread failed. Cannot process reader exit.
Cause:The Windows system did not allow the Integration Service to create a wait thread.
Action:Check for errors in the Integration Service log. If no errors appear, restart the Integration Service. If the problem persists, contact Informatica Technical Support.
TM_6096Error fetching FTP information from repository.
Cause:Internal error.
Action:Contact Informatica Technical Support.

TM_6099Error in executing post-session shell commands: session <session name>.
Cause:An error occurred while executing post-session shell commands for the specified session.
Action:Make sure all post-session shell commands are specified correctly, and those commands can be found in the Integration Service account path.
TM_6100ERROR: Insufficient number of data blocks for targets and sources. Increase DTM buffer size or reduce buffer block size.
Cause:The session does not have enough buffer blocks.
Action:Increase the DTM buffer size in the session properties.
Action:Reduce the buffer block size in the session properties.
TM_6109Warning! The size of the DTM buffer allocated for each DTM is recommended not to exceed <number> bytes. The specified size of DTM buffer is <number> bytes.
Cause:The DTM buffer size exceeded the recommended size.
Action:The Integration Service started with the shared memory size you specified. If you want to change the memory size, stop the Integration Service, change the number of bytes to the specified size, then restart the Integration Service.

TM_6110Warning! The index cache size for a session is recommended not to exceed <number> bytes. The specified index cache size is <number> bytes.
Cause:The index cache size for the session exceeded the recommended size.
Action:Verify the index cache size in the session properties.

Above are list of Informatica Error Messages or Warnings received while performing certain operation against Informatica related products.

What are Informatica Error Messages?

Informatica error codes are a set of error codes for use by all Informatica products. Every Informatica error message returned by Informatica, is self explanatory and contains the object name in cases where required.

Hope this was helpful.

SQLServerF1 Team
Information about Informatica Error Code Messages or Warning Messages on Windows and Linux Operating Systems.


Leave a Reply

Your email address will not be published. Required fields are marked *