Troubleshooting Informatica Error Messages and Resolution – Part 334

SQLServerF1

SEBL_30013Application source qualifier <application source qualifier name> has invalid join and/or filter override <join override> with character error at <number> location.
Cause:You entered a join condition and/or source filter condition that contain characters that are not valid in the application connection code page.
Action:Edit the join and/or filter conditions so all characters are valid in the application connection code page.

SEBL_30014Application source qualifier <application source qualifier name> has more than one business component attached.
Cause:The listed application source qualifier is associated or connected to more than one Siebel business component source definition. You can associate or connect only one business component source definition to a single application source qualifier.
Action:Disconnect one of the business component source definitions from the application source qualifier.
or
Action:Remove one of the associated business component source definitions.
or
Action:To use more than one business component in a single mapping, create an application source qualifier for each business component you want to use. Use a Joiner transformation to join two related business components.
SEBL_30015Application source qualifier <application source qualifier name> has business component and other sources.
Cause:The listed application source qualifier is connected to a business component source definition and other source definitions. You cannot join a business component with other Siebel sources.
Action:Use a separate application source qualifier for each Siebel source definition.

SEBL_30019Application source qualifier <application source qualifier name> has filter clause which uses one or more fields that were not selected.
Cause:The listed application source qualifier has a filter clause which uses one or more fields that you did not select from the business component.
Action:In the filter clause, only use the fields that you select from the business component.
SEBL_30020Application source qualifier <application source qualifier name> has join override clause which uses one or more fields that were not selected.
Cause:The listed application source qualifier has a join override clause which uses one or more fields that you did not select from the business component.
Action:In the join override clause, only use the fields that you select from the business component.
SEBL_30022Application source qualifier <application source qualifier name> has partitions with key names that use one or more fields that were not selected.
Cause:The listed application source qualifier has partitions with key names that use one or more fields that you did not select from the business component.
Action:For key names in partitions, only use the fields that you select from the business component.
SEBL_30023One or more fields used to partition source(s) of application source qualifier <application source qualifier name> have been deleted.
Cause:You defined a partition key for a port in the application source qualifier that you deleted.
Action:Edit the session to remove the partition key from the application source qualifier. Then save the new partition information in the session and run it again.

Above are list of Informatica Error Messages or Warnings received while performing certain operation against Informatica related products.

What are Informatica Error Messages?

Informatica error codes are a set of error codes for use by all Informatica products. Every Informatica error message returned by Informatica, is self explanatory and contains the object name in cases where required.

Hope this was helpful.

Thanks,
SQLServerF1 Team
Information about Informatica Error Code Messages or Warning Messages on Windows and Linux Operating Systems.

 

Leave a Reply

Your email address will not be published. Required fields are marked *