Troubleshooting Informatica Error Messages and Resolution – Part 276

SQLServerF1

REP_12386There is no database object available for the repository <repository name>. (A repository is not supported on the requested database or the appropriate database driver is not available.
Cause:A repository is not supported on the database type specified in the configuration file.
Action:Check the Integration Service Setup and correct the database type of the repository.

REP_12387The attempt to get a <save/fetch> lock on the <object type> <object name> timed out due to the following conflicting lock: User <user name> on the computer <hostname> running the <application> obtained a <save/fetch> lock on the <object type> <object name> at <time>. Please try again.
Cause:You tried to access or save a repository object, and the repository could not create the necessary fetch or save lock to allow you to perform your task. This occurred because another user has the object locked.
Action:Try again the operation again. If the problem persists, use the information provided to determine if the listed user is accessing the object. If you can verify the object is not being used or accessed, ask the administrator to unlock the object as necessary.
REP_12389Unable to set database connection property <number>.
Cause:A database error prevented the repository connection from setting required database connection parameters.
Action:Make sure the repository database server is up and running. If there is no problem in the database, try connecting to the repository again. If the problem persists, contact Informatica Technical Support.

REP_12390Mapping <mapping name> contains a dependency that points to a non existent port. The mapping is assumed to be invalid.
Cause:You started a session that uses a mapplet, and information about the mapping is inconsistent in the repository.
Action:Open the mapping in the Designer, validate the mapping and save it again. If the problem persists, the inconsistency is in the mapplet used by the mapping. Open the mapplet, validate, and save it. Then validate and save the mapping again.
REP_12392GID creation failed for repository <repository name>.
Cause:Internal error. This might be caused by hardware failure.
Action:Contact Informatica Technical Support.
REP_12403Unable to retrieve locale information.
Cause:The repository cannot find or read the pmlocale.bin file.
Action:Make sure that the pmlocale.bin file is in the installation directory and has not been corrupted by a disk failure.

Above are list of Informatica Error Messages or Warnings received while performing certain operation against Informatica related products.

What are Informatica Error Messages?

Informatica error codes are a set of error codes for use by all Informatica products. Every Informatica error message returned by Informatica, is self explanatory and contains the object name in cases where required.

Hope this was helpful.

Thanks,
SQLServerF1 Team
Information about Informatica Error Code Messages or Warning Messages on Windows and Linux Operating Systems.

 

Leave a Reply

Your email address will not be published. Required fields are marked *