Troubleshooting Informatica Error Messages and Resolution – Part 232

SQLServerF1

OPT_63005ERROR: Pushdown optimization failed for the session <transformation name>.
Cause:Internal error.
Action:Contact Informatica Technical Support.

OPT_63007ERROR: Failed to expand configuration parameter [$$PushdownConfig].
Cause:The Integration Service could not expand the $$PushdownConfig configuration parameter because it could not locate the parameter file or could not locate the specified parameter within the parameter file.
Action:Verify that the parameter file contains the correct path, and a value for the $$PushdownConfig parameter is specified within the file.
OPT_63008ERROR: Configuration parameter [$$PushdownConfig] contains an invalid value.
Cause:The Integration Service could not expand the $$PushdownConfig configuration parameter because the parameter files specifies an invalid value for the $$PushdownConfig parameter.
Action:Verify that the parameter file specifies a valid value for the $$PushdownConfig configuration parameter.
OPT_63014Pushdown optimization to source stops at the transformation <transformation name> because the mapping contains too many pipeline branches.
Cause:The mapping contains more than 64 two-way branches, 43 three-way branches, or 32 four-way branches. The Integration Service cannot generate SQL to push all the branches of the mapping to the database.
Action:None.

OPT_63015Pushdown optimization to target stops at the transformation <transformation name> because the mapping contains too many pipeline branches.
Cause:The mapping contains more than 64 two-way branches, 43 three-way branches, or 32 four-way branches. The Integration Service cannot generate SQL to push all the branches of the mapping to the database.
Action:None.
Action:None.
OPT_63021Pushdown optimization stops at the transformation <transformation name> because it is connected to multiple targets.
Cause:You attempted to push a transformation to multiple targets for target-side partial pushdown optimization. The Integration Service cannot generate the SQL to push the transformation to both targets.

Above are list of Informatica Error Messages or Warnings received while performing certain operation against Informatica related products.

What are Informatica Error Messages?

Informatica error codes are a set of error codes for use by all Informatica products. Every Informatica error message returned by Informatica, is self explanatory and contains the object name in cases where required.

Hope this was helpful.

Thanks,
SQLServerF1 Team
Information about Informatica Error Code Messages or Warning Messages on Windows and Linux Operating Systems.

 

Leave a Reply

Your email address will not be published. Required fields are marked *