Troubleshooting Informatica Error Messages and Resolution – Part 222

SQLServerF1

MQ_29248 MQ queue manager [<queue manager>] encountered a transient connection failure.
Cause:The Integration Service could not connect to the MQ queue manager. The network or the MQ server may be down. The Integration Service will attempt to connect to the MQ queue during the retry connection period. If it does not connect to the MQ queue during the retry connection period the session fails.
Action:Verify the MQ queue manager is running. Or, verify that the network is active.

MQ_29250 Connection retry period expired. The Integration Service could not connect to MQ queue manager [<queue manager>].
Cause:The Integration Service could not connect to the MQ queue manager during the retry connection period. The network or the MQ server may be down. As a result, the session failed.
Action:Verify the MQ queue manager is running. Or, verify that the network is active. Restart the session.
MQ_29251 Resilience is disabled, because Destructive Read and recovery are not configured.
Cause:The Integration Service could not make multiple connection attempts to the MQ queue manager, because Destructive Read and recovery are not configured for the session.
Action:In the session properties, configure Destructive Read and recovery.
MQ_29255 The Integration Service truncated message data while reading from queue <queue>:<queue manager> in destructive read mode.
Cause:The Integration Service read an MQSeries message that exceeded the precision of the MESSAGE_DATA column in the MQSeries source definition. As a result, the Integration Service truncated the data. Because the session is running in destructive read mode, the session failed and the Integration Service did not delete the message from the source queue.
Action:Increase the precision of the MESSAGE_DATA column in the MQSeries source definition.

NODE_10014[Resource type] resource [resource name] not found in node configuration.
Cause:The EnableNodeResource or DisableNodeResource command was used to enable or disable a resource on a node. infacmd could not find a resource with the name and type shown on the node.
Action:Verify the following conditions:
−The resource shown exists on the node.
−The resource is of the type shown.
−The resource name was entered correctly.

Above are list of Informatica Error Messages or Warnings received while performing certain operation against Informatica related products.

What are Informatica Error Messages?

Informatica error codes are a set of error codes for use by all Informatica products. Every Informatica error message returned by Informatica, is self explanatory and contains the object name in cases where required.

Hope this was helpful.

Thanks,
SQLServerF1 Team
Information about Informatica Error Code Messages or Warning Messages on Windows and Linux Operating Systems.

 

Leave a Reply

Your email address will not be published. Required fields are marked *