Troubleshooting Informatica Error Messages and Resolution – Part 220

SQLServerF1_Header_Small

MQ_29225Device failed to back out: <error message>.
Cause:The Integration Service could not roll back messages from the target.
Action:Check the additional error message for more information.
MQ_29226Device failed to connect to queue manager: <error message>.
Cause:The Integration Service could not connect to the queue manager. The session failed to initialize.
Action:Check the additional error message for more information.

MQ_ 29231Transactional MQ targets with the same queue manager name cannot be in different TCUs.
Cause:The MQSeries targets have the same queue connection but belong to different transaction control units. As a result, the session failed.
Action:Make sure that all MQSeries targets with the same queue connection belong to the same transaction control unit.
MQ_29234 Write to recovery cached failed.
Cause:Recovery cache folder is not available.
Action:Check that the recovery cache folder exists and has write permission.
or
Cause:The target may have insufficient disk space.
Action:Verify that enough disk space is available in the target.
MQ_29237Failure occurred while reading messages from the queue in destructive mode.
Cause:The IBM MQSeries installation may not allow deleting messages from the queue.
Action:Look up the reason code in the IBM MQSeries documentation for instructions to correct the error.

MQ_29238Invalid recovery cache folder specified.
Cause:The recovery cache folder is invalid.
Action:From the properties settings on the Mapping tab (Sources node) in the session properties, specify a valid recovery cache folder.
MQ_29239Reader partition <partition name> failed to close checkpoint at real-time flush: <additional error message>.
Cause:There may be insufficient disk space when the Integration Service commits messages to the target after the Real-time Flush Latency period expires.
Action:Verify that enough disk space is available in the target.

Above are list of Informatica Error Messages or Warnings received while performing certain operation against Informatica related products.

What are Informatica Error Messages?

Informatica error codes are a set of error codes for use by all Informatica products. Every Informatica error message returned by Informatica, is self explanatory and contains the object name in cases where required.

Hope this was helpful.

Thanks,
SQLServerF1 Team
Information about Informatica Error Code Messages or Warning Messages on Windows and Linux Operating Systems.

 

Leave a Reply

Your email address will not be published. Required fields are marked *