Troubleshooting Informatica Error Messages and Resolution – Part 219

MQ_29213No filter is specified for queue <queue>:<queue manager>.
Cause:This is an informational message. It indicates that there is no filter set for reading messages from the queue.
Action:None. You can enter a filter condition in the MQ Source Qualifier or in the session properties.
MQ_29214MQ Driver initialization failure <message>.
Cause:An error occurred during the initialization of the MQ driver.
Action:Check the additional error message for more information.

MQ_29218Filter Condition for MQSeries: StartTime should be prior to EndTime.
Cause:This is an informational message. The value for StartTime in the filter condition is equal to or greater than the value entered for EndTime.
Action:Make sure the StartTime value is less than the EndTime value.
MQ_29221Partial message written into queue <queue>:<queue manager> due to commit.
Cause:This is an informational message. The Integration Service did not commit all rows in a message to the target. This might occur when the Integration Service reaches the end of a commit interval or a short FlushLatency interval. It commits the remaining rows at the next commit interval.
Action:None.

MQ_29222Error committing from queue manager <queue manager>: reason <reason> <reason message>.
Cause:The Integration Service could not commit messages to the target. The MQSeries system may not contain enough log space.
Action:Verify that your MQSeries system contains enough log space.
or
Action:Check the additional error message for more information.
MQ_29223Error backing out from queue manager <queue manager>: reason <reason> <reason message>.
Cause:The Integration Service could not roll back messages from the target.
Action:Check the additional error message for more information.
MQ_29224Device failed to commit: <error message>.
Cause:The Integration Service could not commit messages to the target.
Action:Check the additional error message for more information.

Above are list of Informatica Error Messages or Warnings received while performing certain operation against Informatica related products.

What are Informatica Error Messages?

Informatica error codes are a set of error codes for use by all Informatica products. Every Informatica error message returned by Informatica, is self explanatory and contains the object name in cases where required.

Hope this was helpful.

Thanks,
SQLServerF1 Team
Information about Informatica Error Code Messages or Warning Messages on Windows and Linux Operating Systems.

 

Leave a Reply

Your email address will not be published. Required fields are marked *