Troubleshooting Informatica Error Messages and Resolution – Part 161


IDOC_17601 Received a call to an unsupported function <function>.
Cause:The Integration Service received an RFC call from SAP for a function that is not registered to the Integration Service.
Action:Use the RFC Destination created for the Integration Service in SAP to send outbound IDocs only.

IDOC_17605Invalid value specified for IDocParamType. Must be either ControlRecord or SegmentRecord.
Cause:The 6.x IDoc_Prepare AEP transformation contains an invalid value for the IDocParamType property.
Action:Edit the transformation and select either ControlRecord or SegmentRecord for this property.
IDOC_17606Error getting metadata for the IDoc segment <segment name>.
Cause:The Integration Service failed to retrieve the IDoc metadata for a 6.x IDoc mapping.
Action:Verify that the Informatica transports were correctly installed or upgraded.
Action:Verify that the saprfc.ini file is configured according to the instructions in the PowerCenter Installation and Configuration Guide. Also, verify that the RFC Destination created in the SAP system for the Integration Service is valid.

IDOC_17607Property <property> is invalid. Error parsing IDocs list.
Cause:The 6.x IDoc_Writer AEP transformation contains a list of values for the IDocTypeList property that are not separated with the correct delimiter.
Action:Edit the transformation and use a semicolon (;) to separate the list of IDoc types.
IDOC_17608The number of IDoc types in the property <property> does not match the number specified in <property>.
Cause:The number of IDoc types listed in the IDocTypeList property does not match the number specified in the NumberOfIDocTypes property for the 6.x IDoc_Writer AEP transformation.
Action:Edit the transformation so that the value for the NumberOfIDocTypes property matches the number of IDoc types listed in the IDocTypeList property.

Above are list of Informatica Error Messages or Warnings received while performing certain operation against Informatica related products.

What are Informatica Error Messages?

Informatica error codes are a set of error codes for use by all Informatica products. Every Informatica error message returned by Informatica, is self explanatory and contains the object name in cases where required.

Hope this was helpful.

SQLServerF1 Team
Information about Informatica Error Code Messages or Warning Messages on Windows and Linux Operating Systems.


Leave a Reply

Your email address will not be published. Required fields are marked *