Troubleshooting Informatica Error Messages and Resolution – Part 108

BGR_25033Error: Socket sendRequest for ident failed for reqType: <number>.
Cause:Internal error.
Action:Contact Informatica Technical Support.
DBGR_25034Error: Socket set poll failed for reqType: <number>.
Cause:Internal error.
Action:Contact Informatica Technical Support.

DBGR_25035Error: Socket connect failed for reqType: <request type>. Debugger client may have timed out if session start up time exceeded time out value specified in Workflow Manager. Please increase timeout value and try again.
Cause:The DTM could not connect to the Designer due to the Integration Service timeout.
Action:Increase the timeout value for the Integration Service connection in the Workflow Manager and run session again.
DBGR_25036Error: Socket open failed for reqType: <number>.
Cause:Internal error.
Action:Contact Informatica Technical Support.
DBGR_25040Error: Invalid groupId <number> specified for modifying router transformation.
Cause:Internal error.
Action:Contact Informatica Technical Support.

DBGR_25041Error: Invalid groupIndex <number> resulted from groupId <number> specified for modifying Router transformation.
Cause:Internal error.
Action:Contact Informatica Technical Support.
DBGR_25044Data Type mismatch: <value> cannot be used in a condition with port <port name>.
Cause:You entered an invalid value for the port datatype for a conditional breakpoint.
Action:Make sure the value is in the correct format: MM/DD/YYYY hh:mm:ss.
DBGR_25045Error in breakpoint condition: Port <port name> and Port <port name> are from different groups.
Cause:You used ports from different groups when setting a conditional breakpoint using two ports. A Normalizer or an XML Source Qualifier transformation
have ports organized in different groups. The Integration Service reads data from these ports one group at a time.
Action:Do not use ports from different groups to set the conditional breakpoint.

Above are list of Informatica Error Messages or Warnings received while performing certain operation against Informatica related products.

What are Informatica Error Messages?

Informatica error codes are a set of error codes for use by all Informatica products. Every Informatica error message returned by Informatica, is self explanatory and contains the object name in cases where required.

Hope this was helpful.

Thanks,
SQLServerF1 Team
Information about Informatica Error Code Messages or Warning Messages on Windows and Linux Operating Systems.

 

Leave a Reply

Your email address will not be published. Required fields are marked *