Teradata SQL Error and Failure Codes from Error 13451 to 13485

SQLServerF1

13451 Invalid checksum, calculated %X, received in message %X
Explanation: Data was corrupted in transit from the mainframe
Generated By: PDE host channel driver.
For Whom: System Support Representative.
Remedy: This error means that incoming data was corrupted while being transmitted from the TDP to the channel
driver. Contact the Global Support Center; check the tciproto log file for additional messages that may explain this error. Monitor the adapter for other such errors; it may need to be replaced.

13452 Invalid message type %X received from the adapter.
Explanation: A message with an unexpected type was received from the firmware
Generated By: PDE host channel driver.
For Whom: System Support Representative.
Remedy: This error means that the adapter firmware sent the driver a letter of a type that the driver was not prepared to handle. Contact the Global Support Center; check the tciproto log file for possible additional messages that may explain this error.

13460 CreateMutex() lock allocation failed for %s
Explanation: NT system call failed.
Generated By: PDE host channel driver
For Whom: System Support Representative.
Remedy: This error prevents the Teradata Channel Protocol process from initializing. The channel interface will not go
active on the node where this message was issued. Contact the Global Support Center.

13464 IOreq: unknown type:%d cua=%d iorp=%X ctxp=%X
Explanation: TciProto internal error has occurred.
Generated By: PDE host channel driver
For Whom: System Support Representative.
Remedy: Internal Programming Error. Determine who sent the bad IO request or why it got corrupted. Contact the Support
Center.

13468 Message Subsystem failed to translate the message between the New format and the Old format. newaddrp=%X oldaddrp=%X addressclass=%X
Explanation: An error was returned by PDE.
Generated By: PDE channel driver
For Whom: System Support Representative.
Remedy: Determine why the message sub-system sent a bad message. If class == TRANSIENTADDR == 1 then
newaddr->transientaddr.index must be less than 65535. Contact the Support Center.

13477 Message Subsystem sent a message larger than supported by TCI size:%d maximum size=%d mp:%X
Explanation: Received a response message from PDE that is too large to process.
Generated By: PDE host channel driver
For Whom: System Support Representative.
Remedy: Determine why the message sub-system sent a bad message. Currently the upper limit is 64KB. Contact the
Support Center.

13480 Uncorrectable channel CRC error Slot = %d Port = %X
Explanation: An uncorrectable CRC error has occurred on the channel.
Generated By: PDE channel interface driver.
For Whom: System Support Representative.
Remedy: Contact the Global Support Center. Possible problem with the channel path for the affected devices, causing
data integrity problems.

13482 Slot = %d Channel Adapter taken out of service
Explanation: A transfer over the bus was corrupted. Probable hardware failure.
Generated By: PDE channel interface driver.
For Whom: System Support Representative.
Remedy: Probable hardware failure. Replace the channel adapter.

13484 Teradata Channel Driver: fault %d, subtype %d on %s
Explanation: A soft fault occurred on the adapter.
Generated By: PDE channel interface driver.
For Whom: System Support Representative.
Remedy: The adapter firmware or kernel driver reported this error. The the channel interface was able to recover from it.
Trace data may have been automatically saved. Please check the driver’s log file for more detailed messages about the error
and the driver’s attempts to capture diagnostic data.

13485 Teradata Channel Driver: error accessing TdTempDir %d, line %d path %s
Explanation: The repository for channel diagnostics and logs either does not exist or is write protected. Channel interface
is disabled until the problem is corrected. Write access to the diagnostics directory is required for proper functioning of
the Teradata Channel Interface.
Generated By: PDE channel interface driver.
For Whom: System Support Representative.
Remedy: Ensure that the directory TdTempDir/tchn/data exists and is not write protected.

Above are list of Teradata Errors or Failure Codes from Error 13451 to 13485 received while performing certain operation against Teradata Database or related products.

What are Teradata Database Errors?

In general, each Teradata error message contains the following information:
• The message number.
• The message text. This text is usually returned with the message number. Some messages employ word substitution, where the word substituted represents the system-replacement of a term more specific to the occurrence.
• An explanation of how the error may have occurred.
• Generated-by text that indicates the software module which initiated the message. This field serves a diagnostic purpose for support and development personnel.
• A remedy which suggests how to resolve the condition.

Hope this was helpful.

Thanks,
SQLServerF1 Team
Information about Teradata SQL Error and Failure Codes and Error Messages on Windows, Linux Operating Systems.

 

Leave a Reply

Your email address will not be published. Required fields are marked *