Symantec NetBackup status code 2041 to status code 2045
Symantec NetBackup product is a backup and recovery product designed for enterprise users. Symantec NetBackup tool can be used to perform backups of SQL Server databases and provides various features.
Below are some of the NetBackup status error codes from Status Code 2041 to Status Code 2045 which may be received while using the Symantec NetBackup tool.
NetBackup status code: 2041
Message: Storage unit is down
Explanation: A disk storage unit has been designated as down and cannot be
Recommended Action: Run the bperror -disk command to indicate why the
disk is considered down.
NetBackup status code: 2042
Message: Density mismatch detected
Explanation: This error is an internal NetBackup error.Ajob has requested media
with the wrong density. A mismatch may exist between the image catalog and the
RecommendedAction: Restore the jobs request tape media by media ID density.
If the requested density does not match the configured density for the media, it
cannot be allocated.
NetBackup status code: 2043
Message: Requested slot is empty
Explanation: Media is not found in the expected slot in the robot.
Recommended Action: The robot may need to be inventoried.
NetBackup status code: 2044
Message: Media is assigned to another application
Explanation: Requested media cannot be allocated because it is assigned to an
application other than NetBackup.
Recommended Action: Verify that media that is required for the job is assigned
NetBackup status code: 2045
Message: Storage unit is disabled since max job count is less than 1
Explanation: Storage unit cannot be used because its maximum job count is set
RecommendedAction: Increase themaximumjob count (ormaximumconcurrent
drive count) to a value greater than 0.
Hope this was helpful.
In-Depth Blogs on SQL Server, Information about NetBackup status codes, SQL Server Frequently asked questions, SQL Server Trainings.