Oracle Database Errors or Warnings from Error ORA-44817 to ORA-44905

SQLServerF1

ORA-44817: Classifier list is too large
Cause: The length of the classifier list was greater than 2048 bytes.
Action: Break the list into two lists before submission.
ORA-44818: General failure
Cause: There was an unknown failure.
Action: Contact Oracle Support Services.
ORA-44819: Execution of this WLM function is denied
Cause: Either a WLM plan was being loaded from another instance, or the strict order of the PL/SQL calls for loading WLM plan was not followed.
Action: Check if another session is also concurrently trying to load a WLM plan. If that is not true, check the order in which you are making these PL/SQL calls to load your WLM plan.

ORA-44820: Number of Work Request Classes is less than specified
Cause: The number of Work Request Classes submitted were less than what was specified.
Action: Submit the full list of Work Request Classes.
ORA-44821: Number of classifiers is too large
Cause: A very large number ( > 1024) of classifiers were requested.
Action: Submit a smaller ( < 1024) number of classifiers. /////////////////////////////////////////////////////////////////////////// 44901 – 44950 reserved for XML DB LINKS related error codes. ///////////////////////////////////////////////////////////////////////////
ORA-44901: Unable to resolve symbolic link “string”
Cause: The system is unable to resolve the specified symbolic link.
Action: Check the definition of the symbolic link to ensure that this refers to a valid resource.

ORA-44902: Too many steps in resolving symbolic link “string”
Cause: This error is raised when the system is unable to fully resolve a path with symbolic links within a reasonable number of steps. It could be due to cycles in definitions of symbolic links or very long chains of symbolic links to symbolic links.
Action: Remove any cycles in symbolic link definitions. If there are no cycles, reduce the length of chains of symbolic links to symbolic links.
ORA-44903: Cannot create hard link to specified resource
Cause: The system cannot create a hard link to the specified resource.
Action: Check the configuration parameter(s) to verify the restrictions on creating hard links to folder or non-folder resources.
ORA-44904: target path in document link exceeds maximum length
Cause: Target path length exceeds the maximum which can be stored to disk.
Action: Reduce target path to smaller length
ORA-44905: extended link type not supported
Cause: XLink type attribute is extended.
Action: Remove extended link, or replace with simple link.

Above are list of Oracle Database Errors or Warnings from Error ORA-44817 to ORA-44905 received while performing certain operation against Oracle Database or related products.

What are atOracle Database Error Messages?

Oracle Error Messages may be returned while using products which are part of Oracle Database. Each Oracle Dabase Error or Warning Message mentioned above contains the Warning or Error Message Statement, a short explanation of the probable causes of the Error message, and a recommended action.

Hope this was helpful.

Thanks,
SQLServerF1 Team
Information about Oracle Database Error Messages or Warning Messages on Windows and Linux Operating Systems.

 

Leave a Reply

Your email address will not be published. Required fields are marked *