Informix Error Messages and Error Codes From Error 25533 to 25545

SQLServerF1

Informix Error Code 25533 The sqlexecd daemon cannot close the network. Enter your request again. If the problem persists, refer to your system manual for more information Informix Error Code 25534 The sqlexecd daemon cannot allocate a structure.
Enter your request again. If the problem persists, refer to your system manual for more information.
Informix Error Code 25535 Address translation failed in sqlexecd daemon.

Enter your request again. If the problem persists, refer to your system manual for more information.
Informix Error Code 25537 The sqlexecd daemon cannot connect to network.
Check that you correctly installed your TCP/IP or StarGROUP network. Check for malfunctions in the network.
Informix Error Code 25543 You specified an unknown service name or protocol.
Examine the /etc/services file to verify that the requested service name exists. Also check that the /etc/services file specifies the correct protocol and/or port number.

Informix Error Code 25544 The sqlexecd daemon cannot find a host structure.
Check that you requested a valid server name. Examine the /etc/hosts file to verify that you correctly defined the requested server name, client address, and host names.
Informix Error Code 25545 The sqlexecd daemon cannot advertise the specified service name.
You are starting the sqlexecd daemon on a system that is running portable INFORMIX-OnLine for NetWare with IPX/SPX as the network protocol, but the daemon is unable to advertise the service name for the database server on the NetWare network. It is possible that another sqlexecd daemon is already using the same service name, a recently stopped sqlexecd daemon with the same service name was unable to de-advertise its service, or the database server is down.
The service name of each database server must be unique across the entire NetWare network. The default service name is sqlexec. If another sqlexecd daemon or database server on the network already uses the name, use a different service name to start the sqlexecd daemon. You can explicitly specify a service name as a parameter in the sqlexecd command line.
If you are restarting a recently terminated sqlexecd daemon, the previous sqlexecd probably has not finished de-advertising or was unable to de-advertise the service name. When you terminate an sqlexecd daemon, use the TERM signal (15) only (that is, kill -15 pid or kill pid). If you do not terminate a service properly, depending on your database server configuration, it might take about three minutes for a terminated service to be de-advertised automatically.

Above are list of Informix Error Messages and Errors Codes or Status Codes or Exit Codes along with Error and Warning messages received while performing certain operation against Informix applications or related products.

What are Informix Error Messages?
All Informix messages returned by the Informix server are assigned an error code.

In general, each Informix error contains the following information:
• The Informix Error Code or Informix Error status
• The message text. This text is usually returned with the Error code. Some messages employ word substitution, where the word substituted represents the system-replacement of a term more specific to the occurrence.
• An explanation of how the error may have occurred.

Hope this was helpful.

Thanks,
SQLServerF1 Team
Information about Informix Error Codes or Status Codes or Exit Codes and Error Messages on Windows, Linux Operating Systems.

 

Leave a Reply

Your email address will not be published. Required fields are marked *