Informix Error Messages and Error Codes From Error 16347 to 16351

SQLServerF1

Informix Error Code -16347 Invalid breakpoint or tracepoint number name specified.
You cannot specify a reference number in an ENABLE, DISABLE, NOBREAK, or NOTRACE command with a zero or negative value, or a value for which no corresponding breakpoint or tracepoint currently exists. You can enter list break trace to display your current reference numbers.

Informix Error Code -16348 Breakpoint or tracepoint name is not active.
You asked the DISABLE command to deactivate a breakpoint that is already disabled. Check that you named the breakpoint that you intended. You can enter list break trace to display your current breakpoints and tracepoints.
Informix Error Code -16349 Use nobreak for breakpoints and notrace for tracepoints.
You specified a breakpoint to the NOTRACE command or a tracepoint to the NOBREAK command. Each command can deal only with its own objects.

Informix Error Code -16350 Breakpoint/tracepoint already disabled/enabled or can’t be determined.
The Debugger cannot find a corresponding breakpoint or tracepoint on which to carry out your ENABLE or DISABLE command. You can enter list break trace to display all your current reference points.
Informix Error Code -16351 Variable variable-name could not be located.
The Debugger cannot reference a variable unless it is defined in a 4GL module. For 4GL variables, check that you entered the variable name correctly. If the variable is not in the current function or module, you must qualify its name. See the section on “Scope of Reference” in the Debugger manual. (This message can appear if you enter what you intend to be a module name in a BREAK or TRACE command, but you omit the dot at the end of the name.)

Above are list of Informix Error Messages and Errors Codes or Status Codes or Exit Codes along with Error and Warning messages received while performing certain operation against Informix applications or related products.

What are Informix Error Messages?
All Informix messages returned by the Informix server are assigned an error code.

In general, each Informix error contains the following information:
• The Informix Error Code or Informix Error status
• The message text. This text is usually returned with the Error code. Some messages employ word substitution, where the word substituted represents the system-replacement of a term more specific to the occurrence.
• An explanation of how the error may have occurred.

Hope this was helpful.

Thanks,
SQLServerF1 Team
Information about Informix Error Codes or Status Codes or Exit Codes and Error Messages on Windows, Linux Operating Systems.

 

Leave a Reply

Your email address will not be published. Required fields are marked *